Configuration Mode
Various configuration settings can be adjusted under the configuration
mode such as heating mode, timer mode, maximum heating rate, low
and high temperature limits, temperature unit, temperature offsetting,
temperature control mode, and so on.
You can enter this configuration mode by pressing the CONFIG Button
when the unit is properly connected to a power outlet but not operating.
You can terminate the configuration mode by using one of the following
methods:
Step 1: Press the RUN/STOP Button.
Step 2: Turn the stirrer knob to select YES and push it to confirm the
termination as shown below.
Or turn the stirrer knob clockwise until you get the following ESC
display and then push it to confirm the termination as shown below:
Note also that the configuration mode is automatically terminated if
there is no button operation for more than 20 seconds.
Temperature Unit
Conversion (°C
↔°F)
You can select the desired temperature unit as follows:
Step 1: Press the CONFIG Button
4-14
Section 4
Control Panel
Summary of Contents for Fisherbrand Isotemp RT AVCD HPS Advanced
Page 1: ...Operation Manual Isotemp RT AVCD HPS Advanced Hotplate Stirrer 9240 11 012 V01 12 01 17...
Page 59: ...10 1...
Page 60: ......
