Fisher Scientific Fisherbrand Isotemp RT AVCD HPS Advanced, Operation Manual

Page: 27 / 62

Timer Setting
This unit provides two types of timer mode: immediate timer activation
and delayed timer activation. (For selecting the timer mode, Refer to 4-
16 Selection of the Timer Mode)
[Indicating LED status during timer is activating]
You can stop timer by pushing RUN/STOP Button during timer’s
activation. For both timer modes, the timer setting procedures are the
same:
Step 1: Press the Timer Button to begin the timer setting and also to
check the display showing the current timer setting. Note that
the hour frame is blinking first as shown below.
Step 2: If you want to change the timer setting, select and then save
the desired values into the hour frame and the minute frame by
turning the Stirrer Knob and pushing it for confirmation as
shown below.
Step 3: Now, the unit will display the set temperature for verification as
shown below. Turn the Stirrer Knob to select the desired value
and then press it for confirmation. The following display will
appear momentarily.
4-10
Section 4
Control Panel