background image

7

Securing Your Child

•  Place your child in the seat. Position the restraint pad between 

your child’s legs.

•  Fasten both waist belts to the buckles on each side of the 

restraint pad. 

Make sure you hear a "click" on both sides. 

•  Check to be sure the restraint system is securely attached 

by pulling it away from your child. The restraint should 
remain attached.

IMPORTANT!

 The maximum weight limit for this product is 

9 kg (20 lbs). If your child weighs less than 9 kg (20 lbs), but is 
really active and appears to be able to climb out of the swing, 
immediately discontinue its use.

Waist Belt

Buckle

Restraint Pad

1

2

Restraint System

•  Tighten each waist belt so that the restraint system is snug 

against your child. Please refer to the next section for instructions 
to tighten the waist belt.

To tighten the belts:

 

•  Feed the anchored end of the belt up through the buckle to form 

a loop 

A

. Pull the free end of the belt 

B

. Repeat this procedure 

to tighten the other belt.

To loosen the belts:

 

•  Feed the free end of the belt up through the buckle to form 

a loop 

A

. Enlarge the loop by pulling on the end of the loop 

toward the buckle. Pull the anchored end of the belt to shorten 
the free end of the belt 

B

. Repeat this procedure to loosen the 

other belt.

 

Please Note: 

After adjusting the belts to fit your child, make sure 

you pull on them to be sure they are securely fastened.

3

To prevent serious injury from 
falls and being strangled in the 
restraint system: 

• Always use the restraint system. 
•   Not recommended for children who 

can sit up by themselves (6 months 
approximately, until 9 kg/20 lbs). 

•  Never leave child unattended. 
•   It is dangerous to use this product 

on an elevated surface.

   WARNING

Anchored End

LOOSEN

TIGHTEN

Free End

Free End

Anchored End

Summary of Contents for P6033









Reviews: