00989pr-1079
7
• Make sure you charge the battery for at least 18 hours
using the enclosed Power Wheels
®
6 volt charger
before operating your vehicle for the first time. Charge
the battery for at least 14 hours after each use of the
vehicle. Never charge the battery longer than 30 hours.
Failure to follow these instructions may damage your
battery and will void your warranty.
• Use only a Power Wheels
®
6 volt charger with “6V”
connector (input 120 VAC, 60Hz, with an output of
6 VDC) to charge your Power Wheels
®
6 volt battery.
• You do not need to remove the battery from your
vehicle to recharge it.
• Before charging the battery, examine the battery case
for cracks and other damage which may cause sulfuric
acid (electrolyte) to leak during the charging process.
If damage is detected, do not charge the battery or use
it in your vehicle. Battery acid is very corrosive and can
cause severe damage to surfaces it contacts.
• Do not place the battery on a surface (such as kitchen
counter tops) which could be damaged by the acid
contained inside the battery. Take precautions to
protect the surface on which you place your battery.
• Charge the battery in a well ventilated area.
• Loosen the screw in the battery retainer and remove it.
• Lift the battery retainer and remove the battery from the
battery compartment.
Battery
Battery
Retainer
2
IMPORTANT!
The battery must be removed from
your vehicle for the initial charge in order to complete
assembly. After assembly is complete, you do not need
to remove the battery from your vehicle to recharge it.
• Locate the lock fastener in the back end of the seat.
• Using a slotted screwdriver, turn the lock fastener 1/4
turn to the unlocked position
.
• Lift the seat from the vehicle.
Battery
Connector
Battery must be upright
while charging
Charger
Connector
BATTERY CHARGING
• Plug the battery connector into the charger connector.
• Plug the charger into a standard wall outlet.
Notes:
- If power flow to the wall outlet is controlled by
a switch, make sure the switch is “ON”.
- Use the charger only in a wall outlet. Do not plug the
charger into a ceiling outlet.
• Once the battery is charged, disconnect the battery
connector from the charger connector. Unplug the
charger from the wall outlet. Refer to the Battery
Installation section for instructions on installing
your battery. If your battery is already installed in
your vehicle, simply re-connect the motor harness
connector to the battery.
3
REAR VIEW
1
Children can be harmed by small
parts, sharp edges and sharp points
in the vehicle's unassembled state,
or by electrical items. Care should be
taken in unpacking and assembly of
the vehicle. Children should not handle
parts, including the battery, or help in
assembly of the vehicle.
• Fit
both
the steering column and the handlebar
connector on the handlebar assembly down through
the large hole in the vehicle.
• Fit the handlebar connector back through the lower
slot in the vehicle.
Large Hole
Lower
Slot
Steering Column
Handlebar
Connector
WARNING
ASSEMBLY
Steering
Column
Grille
Hole
in Axle
Front
Wheel
Assembly
Frame
Posts
FRONT BOTTOM VIEW
2
• Turn the vehicle over so that it rests on the handlebar.
• Position the front wheel assembly so that the grille is
toward the front end of the vehicle. Fit the front wheel
assembly onto the frame posts.
• Fit the end of the steering column through the hole in
the front axle.
