asseMbly instructions
Begin by selecting the most even and level surface on which to assemble your M-Scope unit. Remove the transport straps and
un-stack all the components.
Fig. a
Place the two INTERCHANGEABLE base units on the selected ground surface.
Fig. b
If your M-Scope is equipped with the leveling option proceed with step 3, if not, move to step 4. We recommend that bases with the
leveler option be used on uneven surfaces
. Hold the base assembly level, and engage the push-button levelers by depressing
each of the four lever actuators’ pushbuttons
in turn.
Fig.D -
Depressing one of these pushbuttons releases its leveler leg
so it can drop down as far as necessary to reach the floor below. Releasing the pushbutton locks the leg in place. Releasing
the leveler legs while the control unit and bases are level to the ground allows the legs to automatically extend to the
proper length necesssary to hold the M-Scope security gate assembly level.
The leveler legs can make up for low spots in the
ground’s surface up to two inches deep.
M-scoPe
™
Portable WalK-tHrougH Metal Detector
Fig. a
Fig. B
4
Place control unit on top of the two bases.
Fig. c
- This step ensures that the bases are properly spaced, and parallel to
one another. Remove the control unit and proceed to the next step.
Fig. C
Fig. D
step
3
step
2
step
1
DiMensions
• 88” x 43.5” x 23.75”
Portable DiMensions
• 37” x 23” x 26”
WeigHt
• 90 lbs.
sPeciFications
• Temp -20 C to +60 C (-4 F to +140 F)
• Relative Humidity 95% non condensing
battery/ac PoWer
• 2 rechargeable batteries - 40 hours of battery life on a single charge
• AC power options include 110V/60Hz or 220V/50Hz
Warranty
• 24 months parts and labor
note:
This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equip ment does cause harmfill interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try and correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
sPeciFications
21
Huvudkontor Order & Lager: Malux Sweden AB, Box 221, 891 25 Örnsköldsvik. Växel 0660-29 29 00, fax 0660-850 85.
Försäljningskontor: Stockholm, Göteborg, Stenungsund, Kalmar. För adresser: www.malux.se.
Huvudkontor Order & Lager: Malux Sweden AB, Box 221, 891 25 Örnsköldsvik. Växel 0660-29 29 00, fax 0660-850 85.
Försäljningskontor: Stockholm, Göteborg, Stenungsund, Kalmar. För adresser: www.malux.se.
