Lit. No. 74916, Rev. 01
7
July 15, 2020
95150, 95160, 95180-3, 95190-3
T-FRAME TO BLADE ASSEMBLY
1.
Remove the blade wings from the metal shipping
brackets. Discard the shipping brackets and
replace the cutting edge hardware.
2.
Align the hinges of the blade wings. Position the
T‑frame assembly between the blade wings so
that the pivot holes in the T‑frame are aligned with
the holes in the wing hinges.
3.
Insert the pivot pin from top to bottom through all
the hinges as shown below.
4.
With the snowplow in normal operating position,
pull the jack lock to lower the jack to support the
headgear. Release the jack lock to hold the jack in
position.
Pivot Pin
1/2" x 2-7/8"
Clevis Pins
5/32" x 1-1/2"
Cotter Pins
Jack Handle
Jack Lock
Jack
5.
Remove the protective packaging from the
angle rams.
6.
Align the holes in the rod ends of each angle ram
with the corresponding holes on the back of the
blade.
7.
Install a 1/2" x 2‑7/8" clevis pin from the top to
secure each rod to the blade. Secure the clevis
pins with 5/32" x 1‑1/2" cotter pins as shown.
8.
Install the center snow deflector using two
3/8" x 1‑1/2" cap screws and 3/8" locknuts.
9.
Install the blade guides, using two 7/16" lock
washers and two 7/16" nuts for each guide.
Snow
Deflector
3/8" x 1-1/2"
Cap Screw
3/8"
Locknut
Blade Guide
7/16" Lock
Washers
7/16" Nuts
