Lit. No. 74916, Rev. 01
13
July 15, 2020
95150, 95160, 95180-3, 95190-3
Adjusting the Center Cutting Edges
The center cutting edge spacer plate is located on the
T‑frame below the pivot pin hinge.
1.
Place the blade wings in the retracted (vee)
position and check whether the center cutting
edges touch the center cutting edge spacer plate.
If they do not touch the spacer plate, adjust the
center cutting edges as follows.
2.
Loosen the four 5/8" x 2" center cutting edge
carriage bolts, but do not remove them.
3.
Slide the center cutting edges inward until they
contact the spacer plate.
4.
Re‑tighten the center cutting edge carriage bolts
according to the torque chart.
5/8" x 2"
Carriage Bolts
Spacer Plate
Center Cutting Edge
Spacer Plate
Lubricating the Pivot Pin Hinge
Using a rubber‑tipped seal‑off coupler fitting, apply a
good quality multipurpose grease at the five grease
points along the center hinge of the blade.
Grease
Points
