42
Required components/tools:
●
●
T20 star screwdriver
●
●
Flat head screwdriver
Moving the sensor housing (RS18 & RS24 only)
@5
OPTIONAL — CHANGING OVER DOOR HINGES
G
A
B
C
E
F
D
1
Unclip the reed switch from the housing (
A
).
2
Unhook the interceptor board harness from sensor
housing so harness is loose (
B
).
3
Remove the #8x16 screws (2x) from the sensor housing (
C
).
5
Reinstall the sensor housing using #8x16 screws (2x)
into the pre-drilled holes in the cabinet top panel (
E
).
6
Clip the reed switch into the sensor housing in the
pocket closest to the centerline of the cabinet (
F
).
7
Press the harness from the interceptor board into the
forks on the sensor housing (
G
).
4
Move the sensor housing so that the opposite reed switch
clip is aligned with the center of the cabinet (
D
).
