19
!4
CONNECT TO WATER AND POWER SUPPLY
F
A
WARNING!
●
●
The water connection instructions below are intended only for the professional
installer.
●
●
WARNING — connect to potable drinkable water supply only.
●
●
DO NOT install on line pressure above 120psi (827kPa) or below 22psi (150kPa).
●
●
DO NOT use on hot water supply (100°F [38°C max.]).
1
Flush water through the hose prior to connection to the
appliance to remove any debris in the hose.
2
Move the appliance in front of the cabinetry close
enough that you can access behind for power and water
connections.
3
Connect a braided water hose to the water supply valve
(
A
), and insert the free end of the hose through a hole
at the rear of the plinth (
B
).
4
Push the hose all the way to the front and connect a
brass adaptor (
C
).
Note: The adaptor is not required for installation if (1/4”)
6.35mm PEX plastic tubing (optional) is used.
5
Insert the tube end of the adaptor fully into the PRV (
D
).
6
Secure the connection with a locking clip between the
PRV and hose end of the adaptor (
E
).
7
At the back of your appliance, connect the power cable
to the power supply (115VAC, 60Hz) (
F
).
– You will hear a chime sound when the appliance is
powered on and automatically goes into ‘Installer
(standby) mode’.
– Refer to ‘User guide’ for more details on activating
the appliance.
8
Check the connection and open the water supply to test
for leaks.
Note:
●
●
The water supply connection is only used for freezer
models.
●
●
For dual installation, follow the instructions above for
both first and second appliances.
IMPORTANT!
●
●
Old water fittings (hose-sets) should not be reused.
●
●
The appliance includes a stainless braided water
line hose.
●
●
The shut off valve should be accessible.
●
●
Make sure each appliance is connected to a
separate power outlet.
Required components/tools:
●
●
Water filter installation kit
– 2x Collet locking clip
– 1x 1/4” (6mm) Brass adaptor
– 1x 1/4” (6mm) Stainless steel braided
hose
– 1x Adaptor tube
C
D
E
B
Rear view from
back of appliance
