33
@0
INSTALL DOOR PANELS
Attach the door handle
1
For Stainless steel door panel:
●
●
Remove the plastic plugs from handle holes (4x).
●
●
Align the handle to the holes and secure with M5x25
hex screws (
A
).
For Custom panels:
●
●
Fix the handle with M5x25 hex screws from the inner
edge of the panel.
●
●
Refer to ‘Custom door panel dimensions’ section
to ensure door handle does not interfere with side
attachment brackets.
Hang the door panel
2
Open the door and loosen the screws at both sides of
the door (do not remove) (
B
).
3
Hang the door panel with a small angle to the door by
locating the holes of the top bracket to the M8 studs
(
C
), and rotate the door panel down so that the side
attachment brackets slide onto the side screws of the
door. (
D
)
4
Screw the M8 washer and nut to the stud (
E
), and
re-tighten the side screws (
B
) to fix the door panel
(do not fully tighten). This will allow opening the door
without affecting adjustment of the door panel.
IMPORTANT!
●
●
The assembly of Fisher & Paykel (Stainless steel) door
panels and Custom door panels are outlined below.
●
●
Ensure to protect the finish of the Fisher & Paykel
Stainless steel door panels. Leave the protective film on
the panels when hanging. Remove the film only when
the installation is complete.
●
●
If using Custom door panels, ensure they are prepared
as per ‘Custom door panel dimensions’ section.
Required components/tools:
●
●
4x M5x25 Hex screws
●
●
1x Drill with 3/32” (2.55mm) bit
●
●
1x Cross-head driver on battery drill
●
●
M4 Hex key
●
●
1/2” (13mm) Spanner
IMPORTANT!
We recommended to load the shelves in the
appliance door with weights to ensure an
accurate door panel gap width.
Weight recommendations:
– 18” appliance: 22lbs (10kg)
– 24” appliance: 33lbs (15kg)
– 30” appliance: 44lbs (20kg)
A
D
B
E
C
