24
WASH OPTIONS
Manual water level selection
The agitator has five levels marked on its stem that
can be used to help you select the correct water
level for your load. Select the correct water level by
using the lowest visible mark on the agitator.
●
●
The levels marked on the agitator do not correspond
exactly to the level of the water. They indicate the
level of dry clothes suitable for the water level.
●
●
Your washer may occasionally add water during
agitation. This is to maintain the water level due to
the release of air trapped in the garments.
●
●
The medium/high and medium/low settings are
available on the WashSmart™ model only.
●
●
Out of balance loads, tangling or splash-over can be
caused by selecting a water level that is too high.
Auto water level
WashSmart™ model only
Your washer can automatically select the appropriate water level for the load.
1
Place your clothes in the washer.
2
Select the wash cycle (and select ‘Auto’ water level
if not automatically selected).
3
Press .
During fill, the washer will pause occasionally to
sense the water level. The washer will check if
the water level is correct by using a series of two
different agitate strokes. A slow stroke to sense the
load and an agitate stroke to mix the load. (This
may take over a minute.) If the washer detects that
the water level is not high enough, it will add more
water and re-check the level.
●
●
When washing an unusual load, eg large bulky
garments or pillows, we recommend you manually
select the water level and select the ‘Hand Wash’
cycle (WashSmart™ model) or the ‘Delicate’ cycle
(QuickSmart™ model).
●
●
If there is already water in the bowl, it is best to
manually select the water level.
Note: if you feel the ‘Auto’ water level does not fill to the correct level, you can adjust
the level the washer selects (refer to ‘Changing pre-set options’).
Water level guide on agitator
Selecting ‘Auto’ water level
