5
Installation Instructions
Inlet Hoses
1
Connect the straight ends of the white inlet hoses to the taps.
(There are washers fitted in both ends).
2
Connect the elbow ends of the white inlet hoses to the machine
inlet valves. Inlet valves are marked on the back of the machine.
H = Hot
C = Cold.
Minimum height of taps to clear the top of the machine is 1150mm.
Cold Supply Only:
If you only have a cold water supply, an inlet valve cap (blanking cap) MUST be connected to the
hot inlet valve. The cap prevents water leaking out of the hot valve. The cap is available from your
Fisher & Paykel Dealer or Authorised Service Centre, Part No. 388491. This appliance incorporates
backflow protection complying with AS3500.1. No further backflow protection is required for
connection to the water supply.
Levelling Your Machine
It is IMPORTANT to level the machine to ensure even spin
performance.
1
Separate the 4 rubber foot inserts from the moulding and
fit into the feet on the base of the machine.
2
Move the machine to its final position. (We suggest a
minimum clearance of 20 mm each side).
3
Adjust the feet so the machine is level and cannot rock.
To check if your machine is level:
Look down on the wash bowl and make sure it sits slightly forward of centre (see Diagram 1).
Close the lid. Visually check that the lid fits evenly on both sides. If it does not look like the
diagram in the middle, adjust one of the feet slightly until it matches. The diagram on the top and
bottom are not correct (see Diagram 2).
4
Turn on the water and check all hose connections for leaks. Make sure there are no kinks in the hoses.
5
Uncoil power cord and plug into wall socket.
Tap end
Machine end
Adjustable feet
Rubber insert
To check levelling look
down on the wash bowl
Correct
Incorrect
Diagram 1
Lid Alignment
Lid
Topdeck
Wind right foot down
(out) to correct
Wind left foot down
(out) to correct
Lid
Lid
Topdeck
Topdeck
Diagram 2
Summary of Contents for Intuitive eco IW512
Page 39: ......
