16
After using your
FabricSmart™
washer you may want to fine-tune some of the options to suit
your wash needs.
To access the Settings menu:
■
■
Touch
, select OPTIONS and then
SETTINGS. The SETTINGS menu will then
be displayed.
■
■
Select the option you wish to adjust.
■
■
Adjust the option to your preferred
setting, then touch . This option will be
permanently set.
To adjust the setting again, repeat the above steps.
■
■
To exit SETTINGS, touch .
Wash Temp
The wash temperatures can be adjusted if you think they are too hot or too cold.
■
■
Access the SETTINGS menu (refer above).
■
■
Select WASH TEMP.
■
■
Use the scroll buttons to move the cursor through the boxes to decrease or increase the wash
temperature (the numbers in the boxes are in degrees °C). Each movement is approximately 2°C.
Touch to confirm your selection.
Auto Water Level
If you are not satisfied with the water level that your
FabricSmart™
washer fills to on auto water
level, you can increase or decrease the fill level that auto will select.
■
■
Access the SETTINGS menu (refer above).
■
■
Select AUTO WATER LEVEL.
■
■
Use the scroll buttons to move the cursor through the boxes to decrease or increase the fill level.
The boxes on the left side of the centre point decrease the fill level and those boxes on the right
increase the fill level. Touch to confirm your selection.
Note: if you feel there is not enough water for the load, we recommend you check by pausing
the machine and pushing the clothes down to see how much spare water is at the bottom of the
bowl. Clothes often float and your washer can sense the water under the clothes.
Adjusting the wash settings
Fig.18 To enter the SETTINGS menu,
select SETTINGS in the Options menu.
