- 10 -
Service Manual
Issue
Rev.
4.1.5 Display sceen
4.1.6 Function button
Model No:
DH8060P1
The Lint Filter LED flashes at the start of every
cycle. Flashing stops when start/pause button pressed.
After every 5
drying cycles
the
“
condenser”
LED
flashes
at
the start of the cycle. Flashing stops
when start/pause button pressed.
User warning sounds and “Water Tank” LED will flash
when the dryer detects that the water tank is full.
Delayed start mode is entered by pressing the
“more” key. keys are used to adjust the delay
time. The delay time will increment 5 min, 15 min,
30 min, 1 hr and then in 1 hour increments up to
12 hours.
5 levels of auto sensing moisture
content at end of drying cycle indicated
using combinations of 3 LEDs on the display.
The target moisture remaining at finish of
drying for each setting for different cycles.
3 heat se no heat.
After completion of the drying cycle periodically
rotate the drum and blow cool air (no heat) to
prevent excessive wrinkling or creasing of clothes.
This will continue until the time limit is reached or
when the door is opened. “On” will have a time
limit of 1 hours. “Extra” will do this for 24 hours or
until the power is turned off or start/pause the button
is pressed.
The default setting for all cycles
is Signal “On” LED illuminated and
“Damp dry” LED off.
If blockage detected the dryer
the
LCD will also flashes.
If blockage detected the dryer
the LCD will also flashes.
