Installation test cycle
Ensure the installation test cycle is completed before you dry any items in your dryer. This
is to check that your dryer is installed correctly and that it is functioning properly prior to
use.
1. Turn your dryer on by pressing the ‘POWER’
button.
2. Select the ‘Time Dry’ cycle for 30 minutes. Ensure the drum is empty and the door is closed (you will hear it click
shut).
3. Press
the button. The drum will start rotating.
• Observe the dryer for any problems.
• The dryer will beep and display any faults on the screen if there are any problems. Refer to page 29.
4. At the completion of the cycle open the door and check that there is warmth inside the dryer. This indicates the
dryer is operating normally.
If there are any problems, you must address these before proceeding with normal use. The
dryer will automatically turn off at the end of the cycle if there are no problems.
Before you start, it is a good idea to go through the following checklist:
1. Has the packaging been removed?
2. Is the lint filter correctly in place?
3. Has the power cord been connected to an appropriate power supply and the power turned on?
4. Have you performed the installation test cycle?
Updated: Sun, 09 Feb 2020 16:40:35 GMT
Powered by
10
