17
The main motor is held within a cradle mounted to the base of the dryer. In order to drive the drum,
a poly-v belt is used between the motor pulley and drum. The belt is tensioned via an idler pulley and
tensioner spring attached directly to the motor.
The stainless steel drum is mounted onto the front bearing housing. The rear bearing is fixed to the inside
of the drum by 4 screws and mounted to the heater plate.
The heater is mounted to the element carrier and bolted on to the drum through the rear bearing which
is attached to the cabinet.
6.5 Door catch and strike
6.6 Door micro switch
6.7 Main motor (two different types)
This is a mechanical type strike and catch, when the door is pushed closed the strike is locked into the
catch and holds the door shut.
The door switch is connected to the electronic controller ensuring that when the door is open, voltage to
the motor and elements are cut.
Make
Sanjang
Red - Orange 116
Ω +/- 10%
Type
Split phase reversing
Red - Blue 58
Ω +/- 10%
Power (max)
150W
Orange - Blue 58
Ω +/- 10%
Voltage/ Frequency
220-240v 50 Hz
Run capacitor
6uF
Make
Broad Ocean
Red - Orange 96
Ω +/- 10%
Type
Split phase reversing
Red - Blue 48
Ω +/- 10%
Power (max)
150W
Orange - Blue 48
Ω +/- 10%
Voltage/ Frequency
220-240v 50 Hz
Run capacitor
6uF
6.8 Mechanical parts (Dynamic system)
