Fischer Panda 5000i PVK-U, Manual

Page: 139 / 174

General operation
30.10.12 Chapter 10: General operation - Page 139
10.2.5 Saving settings and exiting the set-up menu ("Save & Exit")
After setting all parameters, you can exit the set-up menu with the menu item "Save & Exit".
Fig. 10.2.5-1: Saving the values to the EEPROM
In doing so, all settings entered in the sub-menus backlight 1,
backlight 2, dimtime, and Network ID are saved to the EEPROM.
Then, the goodbye screen appears for 3 seconds, and the controller is switched off. At the next start of the controller,
the changes will take effect.
10.2.6 Activating/deactivating the autostart function ("Autostart")
WARNING: Automatic start-up
DANGER TO LIFE! - Improper operation can result in health
impairment and death.
While the automatic start-up function is active, the generator can start
up automatically. Before activating it, ensure that the generator cap-
sule is closed and that the corresponding warning signs are affixed to
the generator.
Fig. 10.2.6-1: Set-up menu
To activate the autostart function, select the item "Autostart" in
the set-up menu using the cursor buttons and confirm the
selection with the Start/Stop button.
Fig. 10.2.6-2: "Autostart" sub-menu
In the "Autostart" sub-menu, you can select between the
options "Enable" and "Disable" using the cursor buttons:
To activate the autostart function, select "Enable" and again
confirm your selection with the Start/Stop button.
To deactivate the function, use the menu item "Disable".
The Panda iControl will then confirm your input: