Maintenance Instructions
12.8.20
Kapitel/Chapter 7: Maintenance Instructions - Seite/Page 79
Observe the instructions from your battery manufacturer.
WARNING: System may be pressurised!
The different liquid systems (Cooling System, Fuel system
etc. may pressurised after operation. When the system is
opened, the pressure can be relieved abruptly and expel hot
gases and fluids. Risk of injury due to parts flying about, burn
hazard due to liquids and gases.
7.2 Environmental protection
Environmental protection!
Danger to the environment due to mishandling!
Significant environmental damage can occur, particularly for
incorrect disposal, if environmentally hazardous operating
materials are mishandled. Therefore:
• Always observe the instructions mentioned below.
• Take immediate action if environmentally hazardous
materials reach the environment. Inform the responsible
local authorities about the damage in the case of doubt.
The disposal must be performed by a specialist disposal company.
7.3 Maintenance interval
For the maintenance interval, please see the „General information for PMS generators“ which are attached to this
manual.
At generator with dynamic operation hours (f.e. Generators with iControl2 system) the maintenance interval can may
be extended.
Note:
With the dynamic operation hours the service interval can be
raised up to 30 % (200 h max.). Make sure that the dynamic
operation hours are not reset accidently between the service
interval.
7.4 General maintenance instructions
7.4.1 Checks before each start
• Oil level
• Leaks in the Cooling system
• Visual check for any changes, leaks in the oil drain system,
v-belt, cable connections, hose clips, air filter, fuel lines
Once a month
• Grease/oil the servo motor - Trapezoid thread-spindle
