Assembly instructions Rev 7.1
7
This document is the property of Fischer Connectors.
This document must not be reproduced or distributed, in whole or in part, without prior written permission of Fischer Connectors.
Slowly inject the epoxy inside the
Potting Set Body “G” using the
filling hole located at the bottom
of the Potting Set Body “G”.
Note : the second hole, smaller
and located above the filling hole,
is an overfilling hole. Stop
injecting epoxy when epoxy starts
to flow from this overfilling hole.
Resin Epoxy RS 851-
044 Black
Remove any excess epoxy from
the assembly (if any), apply tape
on both filling and overfilling
holes and place the assembly
onto the curing oven block.
Curing time : 12 hours
@ approx. 23°C.
Apply epoxy on the Shrink Tube
"K" and slide the Bend Relief ”L”
until the end of the Bend Relief
”L” bottoms against the Back Nut
“J”.
Epoxy: RT-355
Resintech
Injection Hole
(2mm)
Overfill hole
Injection
Hole (2mm)
Overfill hole
