12
RPS Touch and RPS (Remote Paging Sensor)
The RPS is an optional feature. The car call/RPS feature uses a small sensor that is mounted
on the inside of your windshield.
RPS Touch (Remote Paging Sensor)
The new RPS touch has multiple features including: remote paging, 4 digit pin unlock/disarm, and
arm/lock. All features are operated with a simple touch of the sensor.
Please have your installer program the RPS Touch controller settings.
RPS Touch and car call functions do not require programming, however in order to unlock/disarm your
vehicle you must program a 4 digit passcode using the instructions below:
STEP 1:
Choose your RPS Touch 4 digit code. ‘0’ is not available.
STEP 2:
Turn ignition to the ‘ON’ position and leave driver’s door open.
STEP 3:
Hold your finger over the ‘Red Circle’ icon for 2.5 seconds.
STEP 4:
When the siren chirps and LED’s flash in a circular pattern, tap on your first number. (Hold the
number for 2.5 seconds to choose 6 through 10.) After choosing your first number you will get one siren
chirp and LED’s will flash in a circular pattern.
STEP 5:
Repeat Step 4 until all four digits are set. You will get 1 siren chirp and 1 parking light flash.
Repeat Steps 2 - 5 if you get 3 chirps and light flashes. Your RPS Touch is now programmed.
Alarm rearm and lock
To rearm, hold your finger on the ‘Red Circle’ for 2.5 seconds.
Alarm disarm and unlock
To disarm, hold your finger over the ‘Red Circle’ for 2.5 seconds. Once the LED’s start their circular
pattern, enter your 4 digit code. (Refer to Step 4 above.) Two seconds after entering the 4th digit, your
system will disarm.
2 Way LCD remote paging
To page a 2 Way LCD remote just tap the ‘Red Circle’ twice.
Touch Panel Sensitivity
To change touch sensitivity open the driver’s door, hold the button on the back of the RPS Touch until
the LED’s go out. Release button and tap again. The number of solid LED’s represent sensitivity of
touch, 1 being the lowest, 5 the highest.
RPS (Remote Paging Sensor) Unlock/Disarm
RPS and car call functions do not require programming, however in order to unlock/disarm your vehicle
you must program a 4 digit passcode using the instructions below:
