11
STEP 1:
Unlock/disarm your system using the remote.
STEP 2:
Press and hold the button on your antenna for 10 seconds. The front LED will stay solid red for
3 seconds then turn off.
STEP 3:
Release the button after 10 seconds and the LED turns on either green or red. Tap the button
once. The LED will change to green or red. Red means that the flashing LED is off. If you tap the
antenna button once and it turns green, the flashing LED is on.
Drive Lock/Ignition Controlled Door Locks
Tap buttons
simultaneously for a half second to turn drive lock on and off (also
known as ignition controlled door locks). The vehicle’s parking lights will flash once and/or siren
chirp once to confirm drive lock is off. The vehicle’s parking lights will flash twice and/or siren chirp twice
to confirm drive lock is on.
IMPORTANT:
Drive lock mode requires additional work from your authorized Firstech dealer. Drive lock
has two settings;
Default 1:
Off
Option 2:
Locks the doors when the ignition is on and after the brake is depressed.
Option 3:
Locks the doors when the RPM’s have reached two times that of idle speed (this setting
requires that a tachometer wire is connected).
With both settings, the doors will unlock when the ignition is turned off. If using this feature on a manual
transmission vehicle, the doors will unlock upon setting the emergency / parking brake.
Turbo Timer Mode
The built-in turbo timer keeps the vehicle’s engine running for either 1, 2, or 4 minutes
(programmable from dealer) after the vehicle key has been removed from the ignition. This
feature will keep oil running through the turbo system to allow for appropriate cooling time.
Tap buttons
simultaneously for a half second to turn on or off turbo mode. The remote will
beep once to confirm that turbo mode is activated. The remote will beep twice to confirm turbo mode is
off.
IMPORTANT:
To utilize this feature, the emergency / parking brake wire must be connected to the
Firstech system. Consult your local authorized dealer for installation.
2
nd
Car Mode (Multiple Vehicle Control)
Most 2 Way remotes have the ability to operate a 2
nd
vehicle. Hold buttons
for 2.5
seconds to activate this feature. The remote’s LED’s will flash and change to red confirming
that 2
nd
car mode is activated. The remote will remain in 2
nd
Car Mode until you hold the
buttons for 2.5 seconds again. The remote will beep twice and the LED’s change from red to
Amber to confirm 2
nd
car mode is off.
IMPORTANT:
2
nd
car mode requires the remote to be programmed to a 2
nd
vehicle that is equipped with
the same RF Kit.
