User notice Primaprotect
version 1.0
8
3.3 Preparing and mounting the posts
Illustration 9 : Mounting the posts.
Remove the four screws from the bottom of the posts and use the anchor bolts provided
with the kit to mount them. Sealing the posts must be carried out carefully
To obtain the best resistance of the posts, it is advised to mount the fastening bracket with
an anchor bolt of at least 800x10 mm. The drilling diameter is 12 mm.
3.4 Plugging the batteries
Plug the 9V then 3V battery packs to the master post as shown below. The siren emits a
beep and the LEDs light up (the LEDs of the two receiving cells start blinking and the
middle red LED of the master post light up continuously (see illustration 3) .
Figure 10 : Plugging the batteries to the master post.
Concrete
> 50cm
> 30cm
9V battery pack
3V battery pack
9V Connector
3V Connector
Summary of Contents for PRIMAPROTECT
Page 14: ......
