20
Assembly Instructions – VX-2
STEP 6
Installing S-Bend and Frame Tensioning Bolt - VX-2
a)
Carefully lower the Rower to its normal operating
position to complete assembly with S-bend
installation and Frame Tension Cable.
Install rear of S-Bend[8] onto the Upper Frame
using M10x80mm Bolt[14], M10 Nyloc Nut[17]
and 2 x M10 Washers[20].
b)
Attach the S-Bend to the Footplate as shown. Tilt
the Upper Frame slightly forward to align in the
proper position.
Note: The M10x15mm S-Bend Bolt with washer is
pre-installed on the S-Bend for your convenience.
c)
Align the Frame Tension Cable[4] eyelet with the
Bracket on Lower Frame and install with
M10x40mm Bolt[11], 4x M10 Plastic Washers[19]
(2 either side of eyelet and inside the Metal
Bracket) and M10 Nyloc Nut[17].
REQUIRED
Frame Tension Cable[4]
S-Bend [8]
M10x40mm Bolt [11]
M10x80mm Bolt [14]
2 x M10 Nyloc Nut [17]
4 x M10 Plastic Washers [19]
2 x M10 Washers [20]
d)
Align and screw the opposite end into the Rear Leg
as shown. Tension until taut and then secure with
Retaining Nut.
c)
a)
b)
c)
d)
b)
a)
d)
Summary of Contents for Fluid FR-E316
Page 1: ...USER GUIDE FR 316 VX 2 ...
