BUNGEE CORD REPLACEMENT
a) Open yellow tank plug, insert wrench to catch the impeller blades. Loosen rear
Mainshaft Bolt using 6mm Allen Key.
a) Remove Magnetic Ring and C-Clip to access Bungee Cord.
a) Remove Belt/Bungee Pulley from shaft and pull Bungee Cord through the Belt/Bungee
Pulley. Feed the new Bungee Cord through until knotted end is securely in place.
STEP 4
STEP 5
STEP 6
OPEN TANK PLUG
REMOVE MAGNETIC RING
INSERT NEW BUNGEE CORD
DO NOT ALLOW
DISSIMILAR METAL
DIRECT CONTACT TO
IMPELLER BLADES,
RUSTING CAN OCCUR.
DO NOT LOOSEN THE BELT.
DO NOT INSERT FINGERS
INTO THE WATER TANK,
IMPELLER BLADES
ARE SHARP!
CAUTION
CAUTION
WARNING
C-Clip
Pull up to remove
Push through to replace
25
NOTE:
IT IS RECOMMENDED WRENCH BE WRAPPED IN A LINT FREE CLOTH, PROTECTING
ELECTROPLATING FINISH ON IMPELLER BLADES.
