DO NOT OVER TIGHTEN.
THE MONITOR NEEDS TO
BE ADJUSTABLE FOR
DIFFERENT VIEWING ANGLES.
a) Remove M10x60 Bolt and M10 Dome Nut from rower mainframe.
b) Attach the Rower Monitor to the Computer Stalk using the M10x60 Bolt and M10
Dome Nut.
c) Locate the Heart Rate and Speed Sensor Wires as shown.
d) Connect the 3 x Heart Rate and 2 x Sensor Wires by push the wiring inside the rear of
the console as shown.
STEP 1
INSTALL THE ROWER MONITOR
M10x60 Bolt
[pre-attached to rower]
M10 Dome Nut
[pre-attached to rower]
REQUIRED
CAUTION
a) Lay Upper Mainframe and Tank
1
on its back.
b) Tilt slightly to one side and allow Transport Wheels
4
to drop into position.
Secure with M8x35mm Bolts and M8 Washer.
c) Repeat on opposite side.
STEP 2
ATTACH WHEELS TO MAINFRAME AND TANK
Upper Mainframe & Tank
1
Transport Wheels
4
2 x M8x35mm Bolt
(pre-attached to rower)
2 x M8 Washer
(pre-attached to rower)
REQUIRED
ASSEMBLY
E316
VX-2
NOTE:
Heart Rate Wire
Speed Sensor Wire
M8x35mm Bolt
M8 Washer
Transport Wheel
M10 Dome Nut
M10x60mm Bolt
7
FOLLOW STEPS 1 – 9.
FOLLOW STEPS 3 – 9.
