Page 13
Camera Orientation
It’s important the camera is mounted correctly to
ensure the image is not upside down or tilted as
the camera lens can only be positioned one way.
Longer Cable Runs
Longer cable runs may require an upgrade to RG59 Coax cable. First Alert kits ship with economical AV cable that is designed to work well up
to the length of cable provided, usually around 60 feet. If longer distances between camera and DVR are required, you will need to upgrade to
RG59 Coax cable. We provide several lengths up to 300 feet. In addition, if you need to run cable for in-wall installations, then you may require
fire rated cable, FT-4/CMR UL approved for in-wall installations.
system start up
Default Video Output
The default video output for the DVR system is VGA. If you connect a BNC (CVBS)
monitor on initial setup, you will need to use the mouse “Scroll Wheel” to switch to
the BNC output to be able to use the mouse. Roll the mouse “Scroll Wheel” back-
ward to go to BNC and forward to go to VGA. The REMARK screen is shown on
startup.
Power On/Off
To power the system On/Off, connect the power
cable to the DC 12V port on the rear panel. Flip
the toggle switch on in the back of the DVR. At
startup, the system performs a basic system
check and runs an initial loading sequence. After
a few moments, the system loads a live display
view.
Standby Mode
The system can also be put into Standby Mode. Power will remain to the system but
will not be recording. To start/stop Standby Mode:
1. Press and hold the POWER button on the front panel or remote control until the
prompt closes. The system enters standby mode. You can also enter Standby
mode through the Quick Access Menu. See next page.
2. To exit standby mode, press and hold the POWER button on the front panel or
remote control until the system beeps. The system will begin powering up.
User Login
Password
ATTENTION: By default, passwords are disabled on the system. You do not need
to enter a password when accessing any system menus. However, for security
purposes, it is highly recommended to enable passwords on the system using
the Password Menu. See “Password” section for details on setting up passwords.
Click APPLY to access the menus or click EXIT to cancel password setup and
return to the LIVE VIEW screen.
initial setup
system operation
Standby Mode
User Login Menu
Power Switch
Switch between VGA to BNC Output
Slot for exposed
cable installation
