fi regear Key West™ Outdoor Gas Fireplace
27
INSTALLATION
RISER INSTALLATION
(TO CONVERT DINING INTO BAR HEIGHT)
A riser may be installed at the base of the dining table to convert it into a
bar table.
1)
If the unit is already assembled - remove the glass surround and table
top.
2)
Remove the two end panels and LP tank - if installed (see LP tank re-
move section in installation manual). If the unit is connected to a natural
gas line, disconnect the gas.
3)
Remove the end panels and long side panels, place on a clean soft
surface.
6)
Place the dining unit frame on top of the riser - lining up the screw holes
and ensure the drain tube is through the riser drain hole.
4)
Remove the 4 adjustable rubber feet form the bottom of the dining unit
and transfer to the bottom of the riser.
5)
Install the 4 adjustable rubber feet into the bottom of the dining riser.
Seat all the way in and hand tighten.
7)
If using unit with a natural gas connection, position riser with gas line
knockouts over gas supply connection - unless using the LP tank.
On the riser, remove panels by grasping bottom and lift backwards, place
on a soft clean surface.
Knockouts
