REV 8/21/06 Page 6 of 16
OPERATIONAL NOTE: TO CONSERVE BATTERY POWER, CHANGES IN TEMPERATURE ARE ONLY RECORDED EVERY TWO
MINUTES. Additionally, to prevent repeated thermo-cycling of the gas appliance, the sensing unit in the transmitter will only activate
the remote receiver when the temperature change exceeds 2
0
F
(1
0
C
) above or below the SET (desired) temperature. However, if
the “SWING” setting has been changed from the factory setting (2
0
F
/1
0
C
), then thermo-cycling will activate at the new setting of the
“SWING” number.
MANUAL CHECK OF THERMO OPERATION
The operation of the Thermo setting can be checked on demand by adjusting the SET temperature 2
0
F
above or below the room
temperature, which will cause the system to turn ON or OFF, respectively. Normally, however, the system will only respond to
temperature changes every two minutes. NOTE: if “SWING” number has been changed, then activation will occur at the new “SWING”
setting.
When the gas fireplace system is activated, a FLAME icon will display on the LCD screen indicating a signal has been sent from the
transmitter.
OPERATING INSTRUCTIONS
THERMO OPERATION
– (Systems operates thermostatically based on SET TEMP setting, ONLY)
SETTING DESIRED ROOM TEMPERATURE
This remote control system can be thermostatically controlled
when the transmitter is in the THERMO mode (THERMO must
be displayed on the screen).
1.
To set the DESIRED room temperature, press the
MODE button to place the transmitter into THERMO
mode. THERMO ON or OFF will display.
2.
Then press the UP or DOWN button to select the
DESIRED room temperature. The highest SET
temperature is 99
0
F
(32
0
C
). The lowest SET
temperature is 45
0
F
(6
0
C
).
3.
The TRANSMITTER will “sense” the room temperature
every two minutes automatically turning the fireplace ON
or OFF thermostatically.
TEMPERATURE OVERRIDE
– (Operates only in PROGRAM
mode)
The user may change the current SET temperature without
changing the programs stored in the transmitter’s memory.
The OVERRIDE feature will be automatically cancelled at the
start of the next PROGRAM PERIOD.
1.
To change current SET TEMP, press the UP or DOWN
button (Setting will be cancelled automatically when next
program period begins.) The word OVERRIDE will appear
over the SET frame on the LCD.
2.
To cancel temperature OVERRIDE, press SET button.
TEMPERATURE HOLD
– (Operates only in PROGRAM
mode.)
The user may override the SET temperature during any period,
adjusting the SET temperature to a CONSTANT new
SET/HOLD temperature.
1.
Press the UP or DOWN button to change the SET
temperature to the level desired. The word OVERRIDE
will appear in SET frame on the LCD.
TIME
TU
THERMO
ON
FLAME
PM
SET
AHEAD
BACK
PROG
1
2
TEMP
SET
MO
DAY
PROGRAM
OVERRIDE
ON
FLAME
SET
AHEAD
BACK
PROG
1
2
TEMP
SET
MO
DAY
PROGRAM
HOLD
ON
FLAME
SET
AHEAD
BACK
PROG
1,2
3
Summary of Contents for FGP-305
Page 14: ...REV 8 21 06 Page 14 of 16 ...
