REV 8/21/06 Page 13 of 16
6.
Due to handling and shipping of the unit, handling or dropping of the transmitter by the customer, and heat conditions to the
receiver, some units may need an occasional frequency adjustment. This adjustment is made to improve the communication and
operating distance between the transmitter and the receiver. See RECEIVER ADJUSTMENT.
RECEIVER ADJUSTMENT – RECOMMENDED ADJUSTMENT
NOTE: The Slide Button, Gray or Black, covers the ADJ access hole when installed.
A. To adjust at the receiver, use a small slotted screwdriver. Turn the adjustment screw counter-clockwise
about 5 degrees, and 1/8 turn. This should correct the distance problem.
B. If that does not correct the problem, return adjustment screw to original position and then turn adjustment
screw 5 degrees clockwise.
This adjustment is like tuning your radio. If you keep turning the adjustment screw, in either direction, you will
go past the proper setting (tuning).
SPECIFICATIONS
BATTERIES: Transmitter 3.0V- 2 ea. AAA 1.5V, Alkaline
Remote Receiver 6V –4ea. AA 1.5 Alkaline FCC ID No.’s: transmitter –K9L3003; receiver – K9L3301RX
Operating Frequency: 303.8MHZ Canadian IC ID No.’s: transmitter – 2439A-3003; receiver – 2439A-3301RX
FOR
TECHNICAL
U.S.
INQUIRIES
SERVICE,
CALL:
(888)
220-4333
Website:
firegearusa.com
MANUFACTURED EXCLUSIVELY FOR FIREGEAR
FCC REQUIREMENTS
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY
UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S
AUTHORITY TO OPERATE THE EQUIPMENT.
Summary of Contents for FGP-305
Page 14: ...REV 8 21 06 Page 14 of 16 ...
