14
Step 12: Assemble the 4-pc Reflector Dome Top
Tip: To watch a helpful 2 minute instructional video demonstrating how to easily assemble the 4-pc
reflector top, please to go to www.youtube.com and search for:“How To Assemble A Firesense Patio
Heater Reflector Hood”.
Hardware Used: (Note: Hardware is packaged with the 4-pc Reflector Panels)
N: Qt 9) M6 Phillips Head Bolt
O: Qt 9) M6 Cap Nut
Reflector (1) is comprised of 3 - outer pieces and 1 - center piece. Locate all 4 pieces of the Reflector which are
wrapped in bubble wrap. Unwrap and remove all pieces and peel off the protective blue plastic on each piece.
Locate 9 bolts and 9 cap nuts in the plastic bag. Align the 3 - outer pieces with the 1 - center piece and place a
bolt through the center hole on each piece as shown below. Tighten castle nut on each bolt.
Next, align the sides of each outer piece and the center piece and insert the next 3 bolts through both holes.
Tighten castle nuts on bolts. Finally, insert bolt through holes located at outside edge of adjoining panels of the
reflector side pieces (3 bolts required) and tighten castle nuts on bolts.
ASSEMBLY
Summary of Contents for PH01-S XL Series
Page 3: ...3 SAFETY INFORMATION ...
Page 4: ...4 SAFETY INFORMATION ...
