Program Mode
36
411UDAC Document #51073 Rev. D 12/09/2008 P/N 51073:D
Once in Program Mode, the 411UDAC will:
Light the DACT Trouble LED
Activate Relay if programmed for DACT trouble
Ignore all other keys other than those mentioned in this section
Display
00_F
on the Programmer display
Continue to communicate any events not previously acknowledged at a central station prior to entering
Programming Mode
Communicate an 'Off Normal' event to the Central Station
Turn off piezo
While in Program Mode, the first three locations on the left of the Programmer display represent the memory address
and the last location (farthest right) represents the contents of the memory address. The first address displayed is
shown below:
Certain program items will be locked from editing if the communicator is active (dialing, transmitting, etc.). These
programming locations are ‘00-19’ Primary Central Station Phone Number, ‘20’ Primary Central Station Communi-
cations Format, ‘21-24’ Primary Central Station Account Code, ‘30-49’ Secondary Central Station Phone Number,
‘50’ Secondary Central Station Communications Format, ‘51-54’ Secondary Central Station Account Code, ‘61’
Central Station Backup Reporting and ‘145-end’ Event Codes.
To unlock these locations, either wait until the communicator stops transmitting or disable the communicator via
address location 64 by changing the content of this address to ‘0.’
When desired changes have been completed, exit Programming Mode by pressing the
MODE
key, followed by the
4-digit code for an alternate mode and then the
[ENTER/STORE]
key. During Program Mode, if no key is pressed
within 10 minutes, the unit will revert to Normal Mode.
The Programmer cable should not be removed from the 411UDAC unless the unit is in Normal Mode. If the Pro-
grammer cable is removed while the 411UDAC is in a Mode other than Normal Mode, the communicator will auto-
matically revert to Normal Mode following a 10 minute time-out period. Note that if the Programmer is in
Troubleshoot Mode when the cable is removed, the 411UDAC will revert to Normal Mode following a 20 minute
time-out period.
3.3.1 DACT Programming
Primary Central Station Phone Number (00 - 19)
The first twenty addresses (
00 - 19
) are factory set to 'F' (
00_F to 19_F
). Programming is done as follows:
If your phone number is 484-7161, press
4
.
The display will read
00_4
.
Press
[ENTER/STORE]
to save the entry to memory and increment to the next address
01_F
.
Enter the remaining numbers in their respective addresses as shown below:
Valid entries for both the primary and secondary phone numbers are 0 to 9 and A to F with the numeric digits as
dialed numbers and the hexadecimal digits representing the following functions:
• A = * on a Touch-Tone phone keypad
• B = # on a Touch-Tone phone keypad
• C = look for secondary dial tone for up to two seconds (then dial anyway)
00_F
(address)
(data)
4 8 4 7 1 6 1 F F F F F F F F F F F F F
00 01 02 03 04 05 06 07 08 09 10 11 12 13 14 15 16 17 18 19
Entry
Address
Summary of Contents for FIRE-LITE 411UDAC
Page 4: ...4 411UDAC Document 51073 Rev D 12 09 2008 P N 51073 D Notes ...
Page 84: ...84 411UDAC Document 51073 Rev D 12 09 2008 P N 51073 D Notes ...
Page 85: ...411UDAC Document 51073 Rev D 12 09 2008 P N 51073 D 85 Notes ...
Page 86: ...86 411UDAC Document 51073 Rev D 12 09 2008 P N 51073 D Notes ...