Version: June 2018
4
Glass installation process
Note
: Glass installation is best carried out by two people. Check all glass edges and surfaces for damage.
Do not install the glass if it is damaged. Check that the insulating material (ladder rope around the outer edge
of the glass and around the opening of the fire) is complete and undamaged. Do not install the glass if the
insulating material is damaged or missing.
Carefully install the glass, which is held in place by retaining clips along the top of the glass and powerful
magnets in each lower corner.
• On the back corner of each glass there are 3mm steel magnet panels. In one
movement, gently lower the glass down allowing the steel magnet panels to
catch the top front face of the magnets. Take care lowering the glass
completely down into position. The glass will lower onto a 3mm safety
switch pin. There is a safety switch at the base of each glass panel.
• Gently push the top corners of the glass back into position.
•
Tighten the 4mm cap screws that hold the glass retaining clips in position.
Make sure the retaining clips sit flat onto the glass surface.
Safety switch pin