5
INSTALLATION
INSTALLING A REMOTE HEAD:
Remote Heads can be connected to the Digital Intercom unit by plugging the CA Cable plug into the Remote connector shown in
Figure 4. A remote head can be installed on a mounting bracket or flush mount to any flat surface.
Included Mounting Hardware (with remote head):
(4) #6x.75in sheet metal screws
(1)
.28 ID x .56 OD x .25 in black rubber grommet
Included Mounting Hardware (with mounting bracket):
(4) #6 x.50in sheet metal screws
(4) #6 x.75in Machine Screw
(4) #6-32 Hex Nuts
(4) #6 Split Washer
(1) .50” ID Snap-In Grommet
FIGURE 4
Mounting Flush to a Flat Surface
1. Remove the 4 Torx bolts (T-10) and nuts from the corners of the remote head
2. Use the bracket as a template to mark and drill (4) mounting holes: 7/64" diameter for sheet metal screws or 5/ 32" for
machine screws
3. For an installation where the wire passes through the mounting surface, drill a 3/8" hole and install the supplied rubber
grommet. Pass the wire through.
4. For inside installation, mount the panel using the supplied sheet metal screws (4), making sure the cable is not pinched
Recommended torque : 10 in-lbs
5. Determine the correct length for the CA cable, and cut cable to correct length.
Mounting with Bracket
1. Remove the 4 Torx bolts (T-10) and nuts from the corners of the remote head
2. Before mounting the bracket, drill a 3/4" hole at the desired wire pass-through location.
3. Snap the grommet into the bracket as shown in (Figure 5) and then use the bracket as a template to
mark the mounting holes.
4. Drill (4) mounting holes: 7/64" for #6 sheet metal screws or 9/64" for #6 machine screws. Mount the bracket using the included
hardware
5. Secure the Remote Head to the front of the bracket with the included machine screws, split washers,
and nuts as shown in Figure 5.
Recommended torque : 10 in-lbs
6.
Thread the cable through the bracket
assembly as shown in (Figure 5).
7.
Using the supplied cable ties secure the CA Cable
to the bracket anchors as shown (Figure 5).
8. Adjust the panel to a desirable viewing angle with the two hand knobs.
FIGURE 5: Remote Bracket (bottom view)
Connecting Multiple Remote Heads
Up to five remote heads can be used to control a digital intercom. To install multiple remote heads, contact Firecom for a ‘Y’
adapter (PN: A00-0027-10), or splice multiple CA Cables together. Refer to Figure 9 for wiring diagram.
