SAFETY
I32NEW-I26NEW-I21NEW
Rev. 00 del 05/07/04
23/36
4.7. 4.7. FUNCTIONING
The operator, thanks to his/her experience, has to choose the right kind of brush and detergent for the
surfaces that has to be washed and to decide if the floor needs a second washing.
Follow these instructions for a correct washing:
1. press the brushes motor switch;
2. press the solution solenoid valve switch;
3. press the suction switch.
By means of the accelerator pedal the washing brushes and the suction motor are activated. On the
contrary, both the washing brushes and the suction motor are disactivated after a few seconds if the operator
leaves this pedal. Before the surface is completely dry, the operator must switch the solution solenoid valve
off because this is not activated/disactivated by the accelerator pedal.
The operator has to do a second washing if the surface is particularly dirty:
1. wash the surface with the squeegee up and the brushes down;
2. activate the brushes;
3. press the solution solenoid valve switch;
4. leave the solution on the surface to dissolve the dirt;
5. do a second washing with brushes and squeegee down, the suction activated and the solution solenoid
valve open.
Before any operation, make sure that all protections are well fixed.
4.7.1 PREPARING AND STARTING THE MACHINE
If the machine is connected with the battery charger, the operator must firstly disconnect the battery charger
plug from the batteries one and connect the batteries plug with the power supply plug (see picture 4.5.).
Secondly, the operator must fill water lifting the recovery tank up and turning the cap (see detail nr. 1 in
picture nr. 4.7.). Now the operator can seat on the machine, start it and wash the surface.
Picture 4.7
1
