SAFETY
ECOMINI
Rev. 000
18/09/2017
12/37
3.6.
SAFETY SYSTEMS
The machine is equipped with the following safety systems:
Battery plug
: the battery-operated version of the machine has a plug on the rear; if pulled out, all
machine functions will immediately stop. It is therefore important to become familiar with this system
operation because, in case of danger, the operator must pull the plug immediately.
Solution water solenoid valve (machine without rotating squeegee):
The machine is equipped
with a solenoid valve to let scrubbing water out only after the brushes have been powered on, so as
to prevent accidental leaking;
Safety micro for recovery tank removal (ELECTRIC version
): the machine is equipped with a
safety micro switch which interrupts the current supply to the machine whenever the recovery tank is
removed in order to preventing any accidental ignition.
Solution pump and electric floater (machine with rotating squeegee):
The pump allows the
clean water to get to the brush deck; when the tank is empty, the floater stops the pump in order to
prevent any damage to it;
Electronic card (with rotating squeegee):
The electronic card the brush motor operation through
the current consumption;
The machine is also equipped with a
battery voltage control board
. This device ensures that,
should battery charge go down below a given threshold during normal use, the machine is
immediately stopped by the electronic board, preserving battery efficiency.