Finn HydroSeeder T90, Operator Instructions And Parts Manual

Page: 34 / 126

28
RESET REGENERATION STANDBY DUE TO LOW DOC TEMPERATURE
For Reset Regeneration to begin,
the DOC temperature has to be
at a sufficient level. If the DOC
has not reached this temperature
and Reset Regeneration is
required, then a notification
to Increase RPM / Load and
the Regeneration icon will
be displayed. Once the DOC
reaches sufficient temperature,
Reset Regeneration will
begin and a notification and
regeneration icon will display at
the bottom of the screen.
STATIONARY REGENERATION BY ENGINE MANAGEMENT
If the ECU determines that performing the Stationary Regeneration is required, the operator
will be alerted via the control panel that a Stationary Regeneration is required via a Diagnostic
Trouble Code (DTC) even if Regeneration on the control panel is set to Inhibit. The operator
should immediately conduct the Stationary Regeneration by performing the following operation.
1. Move the machine to a well-ventilated and
safe location.
2. Acknowledge the DTC by pressing the
middle soft key on the display marked
“ ”.
3. When the message “Prepare for Stationary
Regeneration Now” is displayed, press the
left soft key marked “
YES
”.
4. When the message “Bring Machine to
Lo-idle Speed and confirm interlocks” is
displayed, make sure that the pump clutch
is disengaged and hydraulic switch on
control box is in the
HYDRAULICS OFF
(down) position. Reduce engine speed to
low idle. Then acknowledge the message
by pressing the middle soft key on the
display marked “ ”.
5. When the message “Ready to begin
Stationary Regeneration Now?” is
displayed, press the left soft key marked
“
YES
”.