Finn HydroSeeder T280, Parts And Operator'S Manual

Page: 23 / 84

APPLICATION OF SLURRY:
I. GENERAL APPLICATION TECHNIQUES
DANGER:
Do not spray toward power lines, transformers or other high voltage con-
ductors.
CAUTION: The driver of the carrying vehicle should remain alert for hazards to
the operator, such as low power lines, hanging branches, etc. Driver
should never start or stop abruptly.
1. Determine which nozzle would best suit the application needs according to the nozzle selection chart
on page 18.
2. Application of seed, fertilizer and lime: Elevate discharge nozzle no less than 10˚ above the area to be
sprayed, allowing the slurry to gently rain onto the seed bed.
3. Application of wood and paper fiber: Whenever possible aim the stream towards the ground to
create a surface with small pock marks which help get seed in contact with ground. Do not allow the
stream to blast away the surface of the seed bed.
4. Generally the most remote area of the seed bed should be covered first. Distance is controlled by
engine speed and nozzle selection. Do NOT partially close the valve to control the distance.
5. While moving along area to be seeded, the operator should move the nozzle back and forth in a slow,
even arc.
6. If application is to be interrupted for a short period of time, disengage the clutch. If shutdown is going
to be for an extended period of time (i.e., lunch break, reloading, etc.), close the valves to prevent slur-
ry from dewatering. Re-engage the clutch to continue application.
7. It may be necessary to slow the agitator as the tank empties to reduce foaming.
II. DISCHARGE THROUGH THE BOOM:
1. Move the discharge valve handle to the open position, the recirculation valve handle to the closed posi-
tion, and engage the clutch. At this time, should the operator want to stop spraying for a short period,
disengage the clutch; then re-engage to continue spraying.
2. When the tank is empty, or when discontinuing discharge for an extended period of time, disengage the
clutch, then immediately move the discharge valve to the closed position, and idle the engine. This will
maintain moisture in the discharge piping and help prevent plugging. Move the agitator control to the
neutral position.
III. PROCEDURES WHEN USING HOSES:
Always pump clear water through the hose before pumping mulch. If the inside hose liner is dry, it will dewater
the mulch causing plugging.
19