Finn HydroSeeder T280, Parts And Operator'S Manual

Page: 13 / 84

6. Radio Remote Control. The radio remote control option provides the operator with pump on/off con-
trol, throttle control, and engine shutdown at the end of the hose. With control of the engine throttle,
the operator can precisely adjust the pump flow to whatever output the situation requires (i.e., for
close-up work around buildings). The ability to remotely shut off the pump allows the operator to
close the recirculation valve for increased performance during hose work. Carrying the remote valve
at the end of the hose becomes unneccessary.
NOTE:
For remote pump on/off control, the clutch cylinder must be connected
to an air supply.
6. Air Flush System. The air flush option uses compressed air to purge any remaining mulch slurry from
the HydroSeeder® hose, the discharge boom and the recirculation piping. To maximize performance, all
discharge plumbing should be purged after every load. The air flush system provides a quick and easy
means of purging without the need to acquire a flush tank and an additional water supply.
PRE-START CHECK:
Safety check to insure operator safety:
1. Check condition of all mounting hardware securing HydroSeeder
®
to truck frame.
2. Make sure bag cutter is in place and secure.
3. Inspect that all railings are in place and secure.
4. Insure that all guards are in place.
5. With the ignition switch on, verify that the amber safety light under the operator’s platform is
flashing.
EQUIPMENT CHECK:
CAUTION:
Equipment check is made with the engine off and all rotating parts
stopped.
1. See that tool kit contains all the prescribed items (see tool list on page 78).
2. Inspect the “slurry-tank” for foreign objects. See #2 and #3 in Maintenance Section of the Safety
Summary Section on page 4.
3. Check fuel level.
4. Check the hydraulic oil level (see hydraulic system for oil specifications).
5. Check engine oil level...for oil type refer to the engine manual.
6. Check fluid level in radiator.
7. Inspect air cleaner for dust and dirt, clean if necessary.
8. Secure the drain plug on the outside-bottom of the slurry-tank.
9. Check to be certain pump drain plug is in place.
9