Finn BARK BLOWER BB-1208, Parts And Operator'S Manual

Page: 29 / 71

23
MAIN MENU
ENGINE RPM : 0
FLOOR % : 25%
ENGINE SET PT : 1500
STATUS
SPEED
DIAGS
OPTIONS
SETTINGS
Sub Menu
Screens
Figure 8
On the right hand side of the “Main Menu” screen are the names of four sub menus. Pressing the yellow but-
ton on the control box next to the sub menu name will take you to the corresponding menu. From the “Main
Menu” you can reach the “Speed”, “Diags” (diagnostics), “Options” and “Settings” sub menus, or screens.
SPEED
FLOOR
SET SPEED : 25%
AIRLOCK
SET SPEED : 75%
SAVED PROGRAM
NO PROGRAM
ENGINE SPEED
ENGINE SETPT : 1500
UP
DOWN
MANUAL
REVERSE
BACK
Figure 9
While in the “Speed” menu, the operator can set the Airlock speed, the Floor speed, load a preset program, and
set the Engine Set Point, or engine speed (see Figure 9). By pressing the yellow buttons, now labeled “Up”
and “Down”, the different options will be highlighted. Rotating the dial in the lower-right of the control screen
will adjust the highlighted option. The “Floor” and “Airlock” selections will range from 0% of capacity to
100% of capacity in 1% increments. The “Engine Speed” selection ranges from 1250 rpm (idle) to 2650 rpm
(full throttle) in 1 rpm increments.
There are four options for “Saved Program”; “No Program”, “Setting 1”, “Setting 2” and “Setting 3”. The “No
Program” selection will use the Floor and Airlock set speeds selected in the “Speed” menu during operation.
If one of the three programs is selected, their set points will override the manually selected ones at start-up.
See chart (pg 24) for the Airlock and Floor set speeds for the three saved programs.