MENU F
MEGA SD - Cod.197DD8100
GB
START-Up AND OpERATION
4.2.4 NETWOrK SETTINGS MENU
This menu is used to set the parameters required for operation of the compressor in a network (in communication with other
similar compressors).
The menu is visible only after connection of the control unit with the CAN-BUS interface module for communication
between compressors.
• Compressor ID
This is the identifier number of the compressor in a set of machines.
• Prefill
when the set of compressors is started with the compressed air system discharged (pressure zero or very Iow), it is usually
necessary to increase the pressure to the minimum working value as quickly as possible. with the PREFILL function enabled,
the compressor participates in system prefilling, bypassing the global control functions in this phase.
The compressors involved in this operation are started quickly in sequence, thus avoiding any overlap of the start-up phases
of two or more machines.
Press the K4 key to return to the
NETWOrK SETTINGS
menu
from submenus.
Visible only if the CAN-buS
interface has been installed.
> NETwORK SETTING <
......
COMPRESSOR ID
n.of service points x
Prefil
n. compr. x
Prefill time
Valv. 5 min.
Max. n. compr. ON
n. compr. 4
Rotation time
sequence 24 ore
Rotation time
delay ON xxx sec
Rotation time
delay OFF xxx sec
