Fimer QUEEN 210, Instruction Manual

Page: 13 / 24

7
ESP
AÑOL
FRANÇAIS
DEUTSCH
ENGLISH
IT
ALIANO
FIGURE 1
(pag. 6)
:
1. Display panel: shows welding current
value during normal operations. It also
displays other parameters relating to the
selected welding method.
- When unit is switched on, welder model
and firmware version.
- When being switched off, ‘OFF’ is
displayed.
- Should the letters ‘E.Ln’ appear on the
display panel and the LED2 lights up, it
means the power supply is below the
standard required.
2. Thermal Protection Signal and low
mains voltage: this lights up when the
unit overheats. Usually this occurs when
the welder duty-factor has been exceeded.
Check that the air-intake grills (17) on the
frontand back of the welder are not
clogged. Leave the welder switched on to
allow the internal components to cool
down. When the LED goes off, normal
welding operations can be resumed.
Should the letters ‘E.Ln’ appear on the
display panel 1 and the LED 2 lights up, it
means the power supply is below the
standard required.
3. Power Inverter Runnig LED: this lights
up when the welder is providing power.
4. MIG Welding Using: please refer to
para. 3.1.
5. Welding program selector: three
distinct settings
MMA: MMA welding setting (Please refer
to para. 3.2)
Manual MIG: welding setting (Please refer
to para. 3.1.1)
SYNERGIC: Synergic welding setting,
providing 6 selectable programmes
(Please refer to paras. 3.1.2 and 3.1.3).
6. Electronic inductance setting knob:
MMA: inactive
MIG (paragraph 3.1.2): electronic
inductance regulator
7. Wire speed regulator knob
MMA: inactive
Manual MIG (paragraph 3.1.1): wire
speed regulator
Synergic short-arc MIG welding
(paragraph 3.1.2): fine-tuning wire speed
regulator (± 20%)
8. Welding current regulator in MMA
and Manual MIG welding mode, power
regulator in synergic MIG welding mode
(according to thickness of workpiece and
wire speed).
9. INACTIVE
10. Welding wire loader button: to feed
the wire through without pressing the torch
button (only for MIG welding). The wire
speed gradually increases from nil to the
highest speed. Feed flow regulation is
easier in this manner.
WARNING: When pressing the wire feeder
button keep the torch well away from your
eyes: The wire can cause serious injury!
WARNING: The wire-feed roller can trap
fingers when rotating.
11. Euroconnector: Fast-connect welding
torch connector Providing welding current,
gas and electric contact of the welding
torch.
12. Air-intake grills
13. Front “-“ socket: Heart connector
14. Front “+“ socket: MMA Electrode
clamp
FIGURE 2
(pag. 6)
:
12. Air-intake grills
15. ON/OFF SWITCH Switches ON or
OFF the unit
16. Rating plate
17. Welding gas hose socket
18. Power supply cable: Input cable
provided with plug. .
FIGURE 3
(pag. 6)
:
19. Welding wire spool
21. Wire-feeder unit
22. Welding wire guide
23. Motor
24. Upper wire-feeder rollers
25. Knurled knob
26. Lower wire-feeder rollers