18
DETERGENT SOLUTION
Add the liquid detergent to the solution tank in the concentration and
manner indicated on the detergent manufacturer's label.
ATTENTION:
The formation of excess foam could damage
the vacuum motor, so use only the minimum amount of
detergent that is necessary.
ATTENTION:
Always use detergents whose manufacturer's
label indicates their suitability for scrubbing machines. Do not
use acid or alkaline products or solvents without this
indication. Acid or alkaline maintenance detergents can be
used, as long as they have pH values between four and ten,
and do not contain oxidising agents, chlorine or bromine,
formaldehyde, mineral solvents.
ATTENTION:
protective gloves should always be worn before
handling detergents or acidic or alkaline solutions, to avoid
serious injury to the hands.
ATTENTION:
always use low-foam detergent. To avoid the
production of foam, put a minimum quantity of antifoam liquid
in the recovery tank before starting to clean. Do not use pure
acids.
INSERTING THE BRUSH INTO THE APPLIANCE
To insert the brush or the pad holder into the brush head unit,
proceed as follows:
1. Take the appliance to its designated maintenance area.
2. Take all necessary steps to ensure that the device is in a safe
condition (see “
MACHINE SAFETY
’”).
3. Block the handlebar in the horizontal position. Push the steering
column control stop lever (1) in the direction indicated by the
arrow (
Fig.1
) and turn the steering column control into the
horizontal position (
Fig.2
).
ATTENTION:
during this process, keep the control handlebar
still, in order to prevent the appliance from moving accidentally.
4. When the handlebar is in the horizontal position, release the stop
lever (1) to lock the handlebar (
Fig. 3
).
5.
Position the appliance with the rear part in contact with the floor
(
Fig.5
), using the handle (2) on the front of the appliance and the
handle (3) for assistance (
Fig.4
).
6.
Insert the brush (4) onto the fixing pin (5) on the appliance. Push
the brush until the tank is in contact with the flange (6) on the
appliance (
Fig.6
).
PREPARING TO WORK
Before beginning to work, it is necessary to:
ATTENTION:
Before commencing the first working cycle,
charge the battery fully; read the usage instructions for the
battery charger provided with the appliance.
1. Before using the appliance, make sure it is in a good, safe
working condition. If everything is not in order, the appliance must
not be used.
2. Take all necessary steps to ensure that the device is in a safe
condition (see “
MACHINE SAFETY
’”).
3. Check that the squeegee rubber blades are suited to the work
to be carried out; if not, ensure that maintenance is carried
out on these (read paragraph “
CHECKING AND CLEANING
SQUEEGEE BODY
”).
4. Check that the condition of the brush is suitable for the work to
be carried out; if not, ensure that maintenance is carried out this
component (read paragraph “
CHECKING AND CLEANING THE
BRUSH
”).
The appliance must not be
transported or parked in its idle
position when the solution tank
and recovery tank are full.
1
4
3
6
2
5
1
3
6
5
2
1
4