COMPONENTS
The following is a description of the FIK-CR-6 mounting framework:
• One or two FIK-CR-6 modules can be installed in a FIK-BB-2 cabinet
The FIK-BB-2 cabinet has a built-in chassis that will accommodate one or two
FIK-CR-6 modules.
FIGURE 1. FIK-BB-2 CABINET
0
1
2 3 4 5 6
7
8
9
0
7
8
6
5
4
3
2
1
9
10
11
12
13
14
15
BASE
ADDRESS
ADDRESS
DISABLE
NONE
ONE
TWO
THREE
0
1
2 3 4 5 6
7
8
9
0
7
8
6
5
4
3
2
1
9
BASE
ADDRESS
ADDRESS
DISABLE
NONE
ONE
TWO
THREE
10
11
12
13
14
15
BACKBOX
MOUNTING
HOLES
FIGURE 2. TYPICAL MOUNTING HOLE LOCATIONS
The front FIK-CR-6 module positions of each chassis are offset below the rear
FIK-CR-6 module positions so that all of the status indicators are visible. For
cabinet dimensions refer to FIK-BB-2 instruction manual.
INSTALLATION STEPS
1. Cabinet Mounting
In a clean, dry area, mount the backbox using the four holes provided in
the back surface of the cabinet.
C0234-05
2. Module Installation
There are two methods for installing a module in the rear position of a
chassis. Method one is for installation of a rear module only, when no
module will be installed in front of it. Refer to Figure 3 for instructions.
Method two is for installation of a rear module when another module
will be installed in the chassis position in front of it. Refer to Figures 4a
and 4b for method two. All necessary screws and standoffs are supplied
with the modules.
C0235-00
2
1
3
C0249-00
FIGURE 3. INSTALLATION OF REAR MODULE ONLY, METHOD ONE
Step 1: Insert the bottom of the FIK-CR-6 module down into a rear slot on the
chassis.
Step 2: Carefully swing the upper edge of the board back towards the back of
the chassis until it touches the two standoffs.
Step 3: Align two 4-40 screws with the two standoffs and tighten.
Step 4: Address and wire the modules according to the instructions in this
manual.
The steps in Figures 4a and 4b describe and illustrate module installation
when the rear chassis position and the position in front of it will be filled.
Front position installation is possible only if the rear position is filled with a
module.
1
C0244-00
FIGURE 4A. INSTALLATION OF FIK-CR-6 MODULE IN A REAR CHASSIS
POSITION, METHOD TWO
Step 1: Insert the bottom edge of the FIK-CR-6 module down into a rear slot
of the chassis.
Step 2: Carefully swing the bottom edge of the board towards the back of the
board until it touches the short standoff attached to the chassis.
Step 3: Align the long standoff with the short standoff and tighten.
2
1
3
C0245-00
FIGURE 4B. INSTALLATION OF FIK-CR-6 MODULE IN FRONT CHASSIS
POSITION
Step 1: Insert the bottom edge of the FIK-CR-6 module down into a front slot
of the chassis.
Step 2: Carefully swing the upper edge of the board towards the back of the
chassis until it touchesthe 1
¼
" (31.75mm) standoffs installed on the
rear module.
Step 3: Align two 4-40 screws with the two standoffs and tighten.
Step 4: Address and wire the modules according to the instructions in this
manual.
2
I56-6894-000
1/15/2021
