External actuators
You have the possibility to control external WLAN-enabled relays with RAZL-2 CO. Connect to the
RAZL-2 CO main column and enable configuration mode. In the menu, open the
External Actuators
entry. Here you can see an overview of the actors that are ready to be connected to the system. Each
actuator displays the name and the most recently sent command. If a - is displayed instead of the com-
mand, the configured timeout for actuators has been exceeded.
Add a new actuator
The actuator must be a participant in the network of RAZL-2 CO. The ip range allowed for external
devices is 10.1.10.2 - 10.1.10.99. Information from the system can be transmitted to the actuator via
placeholders in the Url or the POST request content.
l
Number of guests: {CURRENT_GUESTS}
l
System Status: {SYSTEM STATUS}
l
Result of the event rule: {CONDITION-RESULT}
Press the
Add New Actuator
button. A configuration interface opens with the following properties.
Name
Custom name of the actuator
Event type
Select the event in which to address the actuator.
Event
Select the status of the event. For example, for the event type 'Number of per-
sons changed' is either 'Increasing number of persons' or 'Falling number of per-
sons'
Url of the actuator
Enter the url of the actuator. You can use wildcards in this field. Example of a
url with a Shelly PM1 relay: http://10.1.10.2/relay/0?turn={CONDITION-
RESULT}
Request Header 'Con-
tent-Type'
The default value of 'application/json; charset=utf-8' for the content type usually
does not need to be changed.