Fienza will charge a service fee for each visit to an installation by its technician where it is determined that the fault
is due to poorly executed or unlicensed installation work or where the product is not a genuine Fienza product or
where the product is outside the warranty period. This may be paid in advance by credit card over the phone to a
Fienza technician attending the site and will be refunded if the Fienza product is found to be at fault.
All installations should be carried out by a qualified tradesman in compliance with the national Plumbing and
drainage code and any State or Local Authority Regulations.
1.
Open the box and check all the components.
2.
Insert the expansion fittings (5) into the seat bolt holes in the WC.
3.
Assemble washers (4), hinge fixings (3) and bolts (2) as shown in
the diagram. Leave loosely attached.
4.
Align the hinge housing of the seat with the hinge fixings and
adjust the seat to desired position.
5.
Remove the seat by depressing the chrome release buttons and
lifting upwards.
6.
Tighten the bolts with a Phillips head screwdriver ensuring that
the expansion fittings are secure. Put the decorative cap in the
position then attached the seat on the hinges.
INSTALLATION STEPS
The toilet seat may be removed for cleaning - depress the chrome hinge release buttons and lift up.
Clean only with a soft cloth or sponge using warm water and mild soap or detergent.
Do
not
use any abrasive cleaning materials.
Do
not
use any solvents or corrosive liquids.
CLEANING
VITEROUS CHINA
Fienza quality viterous china is
gauranteed for 5 years from date of
purchase subject to the conditions below.
PLASTICS & ACCESSORIES
Fienza Plastic Cisterns,, Accessories,
Valves, Washers and Fixings are
gauranteed for 1 year from the date of
purchase subject to the conditions below.
CONDITIONS
•
Instalation has been carried out by a
licensed plumber in accordance with
the plumbing code of Australia.
•
All maintenance and adjustments to the
product after the installation have been
carried out by a licensed plumber.
•
No additives have been introduced into
the cistern tank.
•
Only mild household detergents and
soft (non-abrasive) cloth has been used
to clean the product.
•
All goods of substandard quality
manufacture (excluding imperfections
permitted within AS1976 - Viterous
China used in Sanitiary Applications)
will be credited or replaced by Fienza
when advised within the warranty
period, subject to prior inspection and
agreement.
•
Proof of purchse is required for
warranty claims.
LIMITATIONS
To the extent permitted under the Trade
Practices Act and other relevant legislation,
Fienza’s liability is limited to:
•
The cost of replacing the goods, or
•
The cost of obtaining equivalent goods, or
•
The cost of having the goods repaired
•
Fienza is not responsible for any lack of
operation or performance of goods (or any loss
or damage) where goods are used or adapted
for a with other goods not supplied by Fienza.
•
It is the responsibility of the customer and
installer before installation to ensure are
correct and free of obvious visible faults.
•
Fienza is not responsible for the labour and
rectification costs incurred in the above
circumstance.
WARRANTY STATEMENT
CONDITIONS FOR ON-SITE WARRANTY SERVICE CALLS
Decorative cap
Bolt
Hinge fixing
Washer
Expansion fitting
Chrome
release buttons
www.fienza.com.au
INSTALLATION INSTRUCTIONS
