900mm
Parts required to mount
cistern to pan.
Attach cistern bolts into pan.
Tighten from underneath.
Ensure outlet rubber is
fitted to cistern.
Sit cistern onto pan.
Use supplied bolts to
fasten cistern to pan.
TOP INLET SETUP:
Use 300mm flexi hose.
300mm
or
BOTTOM INLET SETUP:
Use 900mm flexi hose. Feed hose down through channel in back of cistern.
1.
The S-pipe should be put into position and cut to suit your set out.
2.
Then attached to the wall using the thread bolt and plate provided.
3.
Now push pan into position hard to ensure the ceramic outlet is pushed into
the S-pipe by approx 50mm. This is so the rubber inside the S-pipe gets a
good seal to stop water leaking.
PLEASE DO NOT SILICONE PAN TO FLOOR UNTIL TOILET HAS BEEN CHECKED FOR LEAKS.
S-TRAP INSTALLATION
DELTA & EMPIRE
All measurements are in millimetres and subject
to change without notice. Effective 1st Jan 2018.
All installations should be carried out by a
qualified tradesman in compliance with the
national Plumbing & Drainage Code and
any State or Local Authority Regulations.
Installation shall be in accordance with AS/NZS
3500 series of standards and AS/NZA 6400.
1
2
3
4
5
6
6
www.fienza.com.au
INSTALLATION INSTRUCTIONS
