Fieldmann FZI 4018 BI, User Manual, Page: 7 / 32

EN
INVERTER GENERATOR USER MANUAL
7 Control panel functions
3. CONTROL PANEL FUNCTIONS
ON/OFF START SWITCH AND CHOKE
Start Switch “OFF”
When the Start Switch is in the “OFF” position the fuel valve is
switched off and the engine will not run.
Start Switch “CHOKE”
When the Start Switch is in the “CHOKE” position the fuel valve is
switched on and the engine can be started.
Start Switch “RUN”
When the Start Switch is in the “RUN” position the fuel valve is
switched on and the engine can run.
Note: The Choke is not required to start a warm engine
OIL WARNING INDICATOR LIGHT
When the oil falls below the minimum level, the oil warning
indicator light comes on and the engine stops automatically. The
engine will not start until the proper amount of oil is in the crank
case.
Note: If the oil warning indicator light does not come on
and the engine stalls, turn the Start Switch to “RUN” and pull the
recoil starter.
ENGINE OVERLOAD INDICATOR LIGHT
If the engine overload indicator light comes on, the generator
s wattage / amperage capacity has been exceeded by
connected electrical devices or by a power surge. When this
occurs, the green AC Pilot Indicator Light will go off. The engine
will continue to run, (but the red Engine Overload Indicator Light
will stay on and power will no longer be supplied to connected
electronic devices.)
HOW TO CORRECT
1. Disconnect any electronic devices then stop the engine.
2. Reduce the total wattage of connected electronic devices until
it is within the generator’s rated output.
3. Inspect the Air Inlet and Control Panel for any blockage.
Remove blockage if found.
4. Restart Engine.
AC Pilot
Indicator light
Overload
Indicator light
Oil Warning
Indicator light