Fieldmann FZI 4018 BI, User Manual, Page: 13 / 32

EN
INVERTER GENERATOR USER MANUAL
13 Operation
HOW TO STOP ENGINE
Turn the Economy switch to the “OFF” position.
Disconnect any electronic device. All loads
MUST be disconnect from the generator. Never start or stop the
engine with electrical devices plugged in to the receptacles.
Turn the 3 in 1 Start Switch to the “OFF” position.
Turn the fuel cap Air Vent to the “OFF” position.
WARNING!
Never start or stop engine with electrical devices plugged in to the receptacles. Failure
to do so could damage the generator and / or connected electrical devices.
Always start the engine and let it stabilize before connecting any electronic devices.
Disconnect all electronic devices before stopping the engine.
HOW TO ATTACH ELECTRONIC DEVICES
1. Before Starting generator
Make sure the generator is grounded (see page 10 for instructions).
Make sure the attached load is within the generator rated output and the receptacle’s rated current.
Make sure all electrical cords and receptacles are in good condition.
Make sure all electronic devices are turned “OFF” before plugging them into the generator.
2. Start engine
3. If the attached load is small, turn the Economy switch to the “ON” position. For a larger load, or if attaching
multiple electronic devices turn the Economy switch to the “OFF” position.
4. Make sure the green AC pilot indicator light is on.
5. When engine has stabilized, plug in and turn on fi rst load. It is strongly recommended to plug in devices with
the largest output fi rst and the smallest output last to help prevent overloading the generator.
6. Allow generator output to stabilize (engine and attached devices run evenly) before plugging in the next load.