EN
14
FDAK 70205-0
WARNING!
Always remove battery pack from your tool when you are assembling parts, making adjustments, cleaning, or
when not in use. Removing battery pack will prevent accidental starting that could cause serious personal injury.
To install:
Place the battery pack in the tool. Align the raised rib on the battery pack with groove in the battery port.
Make sure the latches on each side of the battery pack snap in place and that the battery pack is secured in
the tool before beginning operation.
To remove:
Depress the latches on both sides of the battery pack to release the battery pack and remove it from the tool.
WARNING!
Improperly attached hoses or accessories can become detached under pressure and cause serious injury.
Possible air leaks can cause faulty pressure readings. Make sure all connections are tightly secured.
DUAL HOSES
See Figures 3–4.
The infl ator has two hoses for two types of infl ation. The high pressure hose is for infl ating high pressure items like
tires and sports balls. The low pressure hose is designed for infl ating or defl ating low pressure, high volume items
like air rafts, mattresses, and fl oats.
NOTE:
Pressure gauge and preset features are relative only to high pressure hose applications.
POWER SWITCH
See Figure 5.
Place the power switch in the (I) position to turn on the low pressure pump or the (II) position to turn on the high
pressure pump. Place the switch in the (0) or center position to stop all pump operations.
DIGITAL GAUGE
See Figure 6.
The digital gauge is multifunctional serving as a pressure gauge, monitoring the amount of pressure being
applied to the item being infl ated; pressure is indicated by PSI.
Press the mode button to turn on the digital gauge.
NOTE:
Make sure digital gauge is set at 0 before use. If gauge reads “Err” or needs resetting, press and hold the mode
button for 4–7 seconds.
NOTE:
After preset pressure has been set, pressure setting stays in the gauge memory for 180 seconds. To recall the
previous pressure setting for up to 180 seconds after infl ation, press the (+) or (-) button. To reset preset pressure,
press and hold the mode button.
OPERATION
