Table of Contents
AT-FBUS for Windows NT
vi
© National Instruments Corporation
Chapter 3
Software Installation and Configuration
Install the Software ....................................................................................................... 3-1
Configure the NI-FBUS Software................................................................................. 3-2
Configure the Base Address and IRQ............................................................. 3-2
Configure the Fieldbus Communication Parameters and Interface Name...... 3-3
Configure the Link Active Schedule File ....................................................... 3-3
Using the NI-FBUS Configuration Utility after Installation........................... 3-4
Chapter 4
Begin to Use the NI-FBUS Software
Starting NI-FBUS ......................................................................................................... 4-1
Writing and Compiling Your Application .................................................................... 4-2
Using the NI-FBUS Dialog Utility................................................................................ 4-2
Appendix B
Customer Communication
Figures
Figure 2-1. Installing the AT-FBUS Board.................................................................. 2-2
Figure 2-2. Fieldbus Connector Pinout for the AT-FBUS ........................................... 2-3
Figure 2-3. AT-FBUS/2 Parts Locator Diagram .......................................................... 2-4
Figure 2-4. Memory Base Address Switch Settings for 0D0000 ................................. 2-7
Figure 2-5. Interrupt Jumper Setting for IRQ11 .......................................................... 2-8
